Ok, 1989 G reg red series 2 escort, been resprayed, new arches, wings, front panel, boot floor, outer sills, bla bla bla, delocked, smooth bonnet and smoothed bumpers. All very nice, but battery tray is going a bit, small scratch on passenger door and bumpers have some small scratches. Front bumper has holes for if u had small indicators in it if u had twin headlights. Smoked red rear lights, ultra clear front indicators, new window seals, opening rears.
Engines in it, has done 10k since rebuild,was fine and gearbox fine when taken off road. Scorpion exhaust, stage 2 t3, no play in shaft. Engine has a piper cam and vernier pulley. Clutch is a AP one. Koni adjustables were brand new never seen the road although theyre covered in stone chipping underseal stuff.
Ive got pictures of it being done i the bodyshop showing them putting new arches in, new boot floor, and completely sorting out the roof. No rust here.
Got majority of cossie management stuff, coil pack, twin amps, green injectors, 1.8 sierra alternator set up, level 6 ecu with coil pack board, pectel board. new water and air sensors, all fuel pipe work. The inlet manifold has been smoothed completely, and powdercoated gloss black along with the coil pack bracket, rocker cover, inlet pipe, again all smooth. All vacuum pipe and connectors etc from Jano.
Grs polished cooler, again as new, twin kenlowes, pace alloy rad.
bailey header tank, swirl pot, oil seperator, again all powdercoated gloss black.
Wolfrace 17 inch voodoos, not bad nick, could do with new tyres.
Cossie front and rear discs, powdercoated brake lines under car with inline compensators for rears, goodridge braided hoses. Fuel tank painted red, mint fuel pump holder to go on there, suspension all powercoated or painted. Front calipers are new refurbed from brake engineering. New pads all round and the rear discs are new, fronts excellent and are grooved.
Loom had all its mfi stuff cut out, got a atoad ai606 alarm. Twin gauge a pillar pod with boost and oil pressure, also have volts.
Interior pretty good, no bad sagging on drivers seat, door cards mint with speaker pod door bins.
To finish the car u need:-
-cossie engine bay loom and coil pack loom, a 3 bar map sensor, a tps, a filter, everything else needed i have.
£2500.
sounds alot of money but try doing all that yourself starting from scratch, would cost u best part of 6k to do one havinghad it all resprayed etc.
Cheers, Mike
my number 07970 509204, im in essex
engine bay at present





